Author Topic: UPB Driver doesn't respond to Goto Command  (Read 2490 times)

smk8383

  • Newbie
  • *
  • Posts: 1
    • View Profile
UPB Driver doesn't respond to Goto Command
« on: November 03, 2012, 01:28:49 pm »
I have a UPB switch that I setup to send a "Goto" command for its link when its button is single clicked and an "Activate" command for its link when its button is double clicked.  The "Link Activate" event catches the "Activate" command but nothing seems to catch the "Goto" command.  How can I catch the "Goto" command?

Similarly, there doesn't seem to be a way to catch Blink, Fade Start, and Fade Stop commands.

This is important because the only way to tell the kind of button push (single click, double click, hold, release) that was done is by sending different commands for different button pushes.