Author Topic: Send Raw Command via Onkyo Driver  (Read 2090 times)

ClintonDouglass

  • Jr. Member
  • **
  • Posts: 72
    • View Profile
Send Raw Command via Onkyo Driver
« on: December 28, 2010, 12:48:25 am »
Not sure if I'm doing something wrong but I can't seem to send an RS232 Raw command via the Onkyo driver.

I created a button named "Setup" and within Event Actions I added the action "Send the raw Onkyo Receiver command !OSDMENU." Nothing happens, same with other commands.

John Hughes

  • Administrator
  • Hero Member
  • *****
  • Posts: 2852
    • View Profile
    • Codecore Technologies
Re: Send Raw Command via Onkyo Driver
« Reply #1 on: December 28, 2010, 09:46:58 pm »
I looked into it and the driver prefixes the command you enter with "!1" and it appends it with a carriage return.

I'm not sure of the command you are sending but try just entering "OSDMENU".

The driver will then send "!1OSDMENU\r".   \r=carriage return
John Hughes
Codecore Technologies

ClintonDouglass

  • Jr. Member
  • **
  • Posts: 72
    • View Profile
Re: Send Raw Command via Onkyo Driver
« Reply #2 on: December 28, 2010, 11:35:04 pm »
Presto magical, that did it! Thank you very much!